THE SUSPENSION IN MOTION
Watch the geometry move.
Explore the proposed six-inch wheel-travel layout: four inches of bump and two inches of droop from normal ride height. These are prescribed-motion geometry views, not a prediction of how the springs will support the loaded vehicle.
One wheel station
Side projection. The tire, arm and coilover sit in different lateral planes; overlap in this drawing does not establish physical interference.
Neighbouring wheels articulate independently
Two identical trailing arms at 26-inch pivot spacing. Tire circles use the modelled 21.995-inch diameter, without tire deflection. The hull is held fixed.
Geometry and limits used in these views
Pivot-to-spindle centre distance: 16.693086 in. Pivot height above tub bottom: 7.600 in. Spindle drop below pivot: 8.000 in at ride, 4.000 in at full bump and 10.000 in at full droop. Lower shock eye is at 60% of the pivot-to-spindle distance. Upper eye is 8.790750 in toward the spindle and 10.984494 in above the pivot.
Measured extended shock length: 17.230 in. The 13.189-in compressed reference comes from the catalogue and is not a verified hard-stop length for the actual units. The diagrams show centre-to-centre motion only. They do not include spring forces, damping, tire deformation, frame flex, bracket deflection, or a complete three-dimensional collision check.
At the proposed travel endpoints the calculated eye lengths are approximately 13.417 in and 17.002 in. Separate bump stops and droop limiters still need designing around verified hardware dimensions.